Camden (YSCN)
Airspace
CN ADC is responsible for the Class D airspace within the Camden CTR from SFC to A020.
Tower Closed Procedures
When CN ADC is offline, the airspace reverts to Class G. CTAF procedures apply.
Taxiing
The apron & grass parking areas are outside the manoeuvring area. The runup bays and all connecting taxiways are inside the manoeuvring area, requiring taxi instructions.
Tip
The YSCN Manoeuvring Area chart can be found on the CASA Website.
Aircraft above 5700kg MTOW must only use TWY D between RWY 06/24 and TWY F.
Departures
Aircraft shall advise their intentions with their ready call.
All departing aircraft shall depart via an extended leg of the circuit and climb to A013.
Important
Inbound aircraft enter the CTR at A018. Maintain A013 until clear of the CTR, unless in receipt of a depart on climb instruction.
VFR aircraft will not be given specific frequency transfer instructions when exiting the CTR. Pilots should switch to an appropriate frequency once clear of the zone.
Depart on Climb
Aircraft may request to leave the CTR on climb into the Class G airspace above.
Phraseology
WKM: "Camden Tower, Citabria WKM, upwind departure, ready, request depart on climb"
CN ADC: "WKM, depart on climb, runway 24, cleared for takeoff"
WKM: "Depart on climb, runway 24, cleared for takeoff, WKM"
Start Approval
Start approval is required for all flights intending to operate in the circuit area.
Phraseology
WKM: "Camden Ground, Citabria WKM, for circuits, received Echo, request engine start"
CN SMC: "WKM, Camden Ground, start approved"
WKM: "Start approved, WKM"
Arrivals
Arriving VFR aircraft should track via and report at BRY, MYF, MEG, PIC, or THK, at A018.
When arriving via a VFR inbound point, pilots should expect the following circuit instructions:
| VFR Inbound Point | RWY 06 | RWY 24 |
|---|---|---|
| BRY | "Join downwind runway 06, maintain A018, report 2 miles" |
"Join final runway 24, maintain A018, report Oran Park (ONPK)" |
| MYF | "Join base runway 06, maintain A018, report 2 miles" |
"Join base runway 24, maintain A018, report 2 miles" |
| MEG | "Overfly Camden to join mid-field crosswind runway 06, maintain A018, report overhead" |
"Overfly Camden to join mid-field crosswind runway 24, maintain A018, report overhead" |
| PIC | "Overfly Camden to join mid-field crosswind runway 06, maintain A018, report overhead" |
"Overfly Camden to join mid-field crosswind runway 24, maintain A018, report overhead" |
| THK | "Join final runway 06, maintain A018, report 3 miles" |
"Join downwind runway 24, maintain A018, report 2 miles" |
Phraseology
MWY: "Camden Tower, Citabria MWY, MYF, A018, inbound, received Golf"
CN ADC: "MWY, Camden Tower, join base runway 24, maintain A018, report 2 miles"
MWY: "Join base runway 24, maintain A018, MWY"
MWY:, "MWY, 2 miles"
CN ADC: "MWY, cleared visual approach"
MWY: "Cleared visual approach, MWY"
Circuits
All circuits are to be flown at A013. Low level circuits may be available on request and should be flown at A008.
| Runway | Circuit Direction |
|---|---|
| RWY 06 | Left |
| RWY 10 | Left |
| RWY 24 | Right |
| RWY 28 | Right |
Glider Operations
Glider aircraft and their towplanes utilise two independent grass glider runways on the southwestern side of the aerodrome. The glider runways run parallel to RWY 06/24 and RWY 10/28, with contra circuits which oppose the normal circuit direction.
Simultaneous operations are conducted from both parallel glider strips.
Outside the lateral limits of CN CTR, gliders operate throughout the surrounding and overlying Class G airspace.
ATC responsibilities to aircraft engaged in gliding activity are limited to passing relevant traffic information after the intention to land has been notified. The normal requirements on entry to the CTR do not apply to gliders. Gliders must report entering the CTR and downwind.
Other aircraft must not infringe the glider circuit below A023 when glider operations are in progress.
Helicopter Operations
A helipad is established to the north of RWY 06/24 and is inside the manoeuvring area. Takeoff and landing clearances are required to operate from the helipad.
Helicopter circuits are conducted at A010 inside the fixed wing circuit by day.
By night, all helicopters must comply with fixed wing operations.
Note
During times of low traffic levels, helicopters may request departure from or arrival to the apron/parking area.
IFR Operations
IFR aircraft will be provided with traffic information only and will not receive an airways clearance on the ground. Aircraft planned into the overlying CTA can expect a clearance from SY TCU after departure.
The only instrument approach at YSCN is the RNP-W approach. This approach commences OCTA and enters the CN CTR.
SY TCU will not clear aircraft for the approach and will transfer aircraft to CN ADC at SCNWI. CN ADC will issue airways clearance into the zone. During day VMC, a restriction may be placed on aircraft on the RNP approach to descend not below A018. Pilots conducting a practice approach must treat this altitude as the minima and either commence the missed approach or join the circuit at that point.